Harbor Clean Up
-
-
The OSEI Corporation was asked to find a suitable place to demonstrate OSE II for senator Gollot and the State of Mississippi
-
-
Long Beach harbor and Pass Christian Harbour Mississippi had enormous amounts of oil and oil with dispersant flowing into the harbor areas
-
-
British Petroleum contractors were putting out new boom in both harbors and around the islands even 30 miles out where we had been earlier
-
-
Pass Christian Harbor has a marsh area with oil and oil with dispersant going over and under the short wall booms that had toppled over
-
-
Oil coated the rocks along the Pass Christian rocky shoreline, the marsh area as well as docks and ramps
-
-
Pass Christian Harbor became the choice for our demonstration for the State of Mississippi
-
-
On August 10, 2010 Steven Pedigo along with Kevin Barbier, and David Fakouri OSEI Corporation associates went to Pass Christian Harbor to alert the harbor master to the fact that Senator Gollot had authorized a clean up of the oil in the Harbors large marsh area on the north side of the harbor.
-
-
The Harbor master pointed out there was more and more oil coming into the harbor
-
-
The Harbor master asked if OSE II could be applied to an area where the BP boom had separated, allowing oil into to an area that had some sensitive equipment.
-
-
The OSEI associates set up the equipment and handed over the sprayer and the OSE II so it could be applied
-
-
The oil was thin enough that as OSE II was applied the oil started breaking up immediately and was detoxified in minutes, the adhesion properties were reduced, the fire hazard was eliminated, and the oil was caused to remain floating until it was converted to CO2 and water.
